#DW-1 Leecraft Zero Clearance Miter Saw Insert 10"L x 2-5/8"W
LEECRAFT Phenolic Table Saw Inserts reduce splintering and chip-out on the bottom side of regular or dado table saw cuts. The opening in the insert is cut on the table saw to the exact width of the saw blade’s kerf. The matching kerf prevents thin slices of wood from jamming in between the blade and the throat plate during a cut. It also reduces the amount of tear-out that can happen with a standard insert.
From the Manufacturer
The Zero Clearance concept is simple: the blade cuts its own perfectly sized slot by being raised through a machinable "blank" insert. Most inserts are 1/2-inch thick, high-density phenolic laminate, with a bonded-melamine surface. They offer superior rigidity, flatness, durability, and low friction and should not be confused with inferior HD/PP inserts. There's just no comparison! They feature leveling screws, side and end adjustment screws for a vibration-free fit, rear safety pin for lift-out protection, and a pre-cut blade bottom pocket that provides clearance for fully retracted blades and bevel cuts. Instructions also included. Use carbide-tipped blades only. A pre-cut starter pocket makes cutting the clearance slot easy and a finger hole makes for simple removal and hanging. Colors may vary. Made in USA.
Before ordering please measure your saw throat opening. Then check below to find the proper model for your table saw:
Model #DW-1Leecraft Zero Clearance Miter Saw Insert for DeWalt 12" Miter Saws: DW703, DW704, DW705, DW7055, DW706
Model #MK-1 Leecraft Zero Clearance Miter Saw Insert for Makita Dual Slide Compound Miter Saws: LS1013 (10"), LS1212 (12"), LS1214 (12") | 
